Collector

The Collector unit perfectly synchronizes, delivers and stacks the finished cut sheets, post process and after the in-line Fotoba Cutter.  

Advantages:

Synchronizes and controls the flow of material,
post process to the Collector.

The level surface guarantees that even heavy and extremely flexible media (over 900g/m2) has a clean and exact end cut.

The rigidity load caused by hanging media is eliminated by using the feeder section with the conveyer belts, therefore pulling (distortion warping) in the corners during lateral cutting is avoided.

With pneumatic control, the feeder section with its conveyer belts can be angled up 90 degrees.  This allows free access between post process and the Collector for adjustments.

Spindle motors with the angle of the table is adjusted to the flat table

New optional pneumatically operated side edge alignment kit.


Increase your productivity! Lower your costs!

The Collector is available in 4 versions:

Collector-170

  • For use in combination with post process
  • For materials up to 170 cm wide

Collector-250

  • For use in combination with post process
  • For materials up to 250 cm wide

Collector-320

  • For use in combination with post process
  • For materials up to 320 cm wide

Technical Data:

230V A – 5A

Compressed air connection required:  5 bar

CL 170 Dimensions:  L 250cm x B 180cm x H 100cm

CL 250 Dimensions:  L 250cm x B 270cm x H 100cm

CL 320 Dimensions:  L 250cm x B 360cm x H 100cm

Download PDF

 

Temporarily restricted stock!